This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. #AZUREWAVE TECHNOLOGY INC ASUS MAC ADDRESS PC#However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). Operation is subject to the following two conditions:ġ) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device This device is intended only for OEM integrators under the following conditions:ġ) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, As long as 2 conditions above are met, further transmitter test will not be required. Canadian Regulatory Wireless Notice This device complies with RSS-210 of the Industry Canada Rules. #AZUREWAVE TECHNOLOGY INC ASUS MAC ADDRESS MANUAL#The end user manual shall include all required regulatory information/warning as show in this manual. #AZUREWAVE TECHNOLOGY INC ASUS MAC ADDRESS HOW TO#Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the users manual of the end product which integrates this module. The final end product must be labeled in a visible area with the following: Contains FCC ID: End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. 13 This device is intended only for OEM integrators under the following conditions:ġ) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, As long as 2 conditions above are met, further transmitter test will not be required. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 20cm between the radiator
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |